Anshan Qinglong Mech. & Elec. Co., Ltd. - Marker marking, metal marker, electric etching marker

用户登陆

用户名：
密码：

新用户注册忘记密码？

Product List

	Auto marker
没有小类
	Semi-auto marker
没有小类
	Electric etching marker
Electric etching marker 手写刻印
	Pneumatic Marking Machine
没有小类
	Portable Marking Machine
没有小类
	Film Machine
没有小类
	consumables & accessories
accessories consumables Special marking clamps
	Centrifugal Oil Cleaner
没有小类

Products

Portable Marking Machine >> PLC Control Portable Marking Machine


	No.：	qlplc05
	Name:	PLC Control Portable Marking Machine
	Specification：	PLCP-V
	Index：	0
	Type：	Portable Marking Machine

Product Description

Kinko CPU304 16 bits		Eview MV506L 5.7〞 4-layer grey
Power supply voltage	AC 220V		Total power	Approx. 388W
Max. marking output power（Dual power output）	320W		Max. marking output current	12.8A
Marking voltage	AC 0－25V		Static power	Less than 30W
Marking timing range	0.1－9s		Marking frequency counting range	1－200000
Stencil plate counting range	1－10000		Marking liquid supply counting range	1-100000
Marking liquid flow rate	0.01ml-10ml, adjustable		Air supply pressure	0.2－1Mpa

Brief Description

1. Flexible and easy for marking on products;

2. Higher integration of PLC and lower fault rate;

3. 16-bit PLC to realize higher control accuracy in the marking process;

4. Voltage is shown on the screen.

5. Over-current protection for marking voltage (alarming in case of more than approx. 13A) to prolong the service life of marking power parts;

6. Over-voltage protection for marking voltage (alarming in case of more than approx. 15V) to prevent the stencil plate from burning due to higher voltage;

7. Accurate marking time by milliseconds;

8. Marking conduction testing technology. The marking has to start only after conduction, i.e. it would not start before conduction ( Normally the marking time is counted from the moment of marking cylinder gonging down. However the used marking time is much less than the actual marking time);

9. Fully automatic and intelligent supply of marking liquid without manual interfere after setting up;

10. Automatic supply time of marking liquid can be set up in the initialization at will;

11. Alarm in case of a lack of marking liquid in the storage vessel;

12. Marking counter.

13. Printing frequency counting of stencil plate for the reference of stencil plate change;

14. Water supply counter

15. Alarm when marking is missing.

16. One-key recovery of ex-factory parameters;

17. One-key storage of user parameters;

18. One-key recovery of user parameters;

19. Mark will be made automatically after pushing the bearing into the clamp

20. One workpiece can be marked repetitively 1 to 5 times

21. Touch screen with marking experiences, implies and fault messages and diagnosis for the operators’ reading as any time to master the optimum marking methods and reduce the consumptions;

点击数：211 Entry Time：2008-6-4 【Print】【Close】